AudioQuest 16.4 Feet Irish Red Subwoofer Cable

AudioQuest IRISHRED5M 16.4 Feet Irish Red Subwoofer Cable

Features

• Solid 0.5% Silver Conductors
  Solid conductors eliminate strand-interaction distortion and reduce jitter.
  Solid silver-plated conductors are excellent for very high-frequency applications.
  These signals, being such a high frequency, travel almost exclusively on the
  surface of the conductor. As the surface is made of high-purity silver, the
  performance is very close to that of a solid silver cable, but priced much
  closer to solid copper cable. This is an incredibly cost effective way of
  manufacturing very high-quality subwoofer cables
• Foamed-Polyethylene Insulation
  Any solid material adjacent to a conductor is actually part of an imperfect
  circuit. Wire insulation and circuit board materials all absorb energy (loss).
  Some of this energy is stored and then released as distortion. Irish Red uses
  air-filled Foamed-Polyethylene Insulation on both conductors because air absorbs
  next to no energy and Polyethylene is low-loss and has a benign distortion
  profile. Thanks to all the air in Foamed-PE, it causes much less of the out-of-focus
  effect common to other materials
• Metal-Layer Noise Dissipation System (NDS)
  100% shield coverage is easy. Preventing captured RF Interference from modulating
  the equipment’s ground reference requires AQ’s Noise-Dissipation
  System. Noise-Dissipation System prevents a significant amount of RFI from
  reaching the equipment’s ground plane
• Symmetrical Coax Geometry
  Identical + and – conductors prevent the shield being used as an inferior
  audio conductor
• Cold-Welded Gold-Plated Plugs
  This plug design allows for a connection devoid of solder, which is a common
  source of distortion. Because the ground shells are stamped instead of machined,
  the metal can be chosen for low distortion instead of machinability
• Grounding
  Sometimes there is a hum problem unless the subwoofer and AV receiver (or
  surround-sound processor) are attached to each other using a separate wire.
  If your system has a hum problem, try attaching the little spade-lug tails
  to the metal chassis of the subwoofer amplifier and to the chassis of the
  sending component. Usually, this extra wire will not be needed
• 5 Meter (16.4 Feet)